Windows-RU      KOI8-RU

US Robotics Total Control
NETServer 3.2.5.92

Hardware settings

DIP switches

Please find two DIP switches groups on rear side of the NETServer: "Modem configuration" (DIP SW #1) and "NETServer configuration" (DIP SW #2) and set its like presents on picture:

Console cable(s)

RS232 Signal name Total Control
MP or Netserver 		External Modem
DB9 		External Modem
DB25 		PC (terminal emulator)
DB9 		PC (terminal emulator)
DB25 		PC's RS232
Signal name
RI
DCD
DTR
SGND
RX
TX
CTS
RTS
DSR
DSR 		1
2
3
4
5
6
7
8
-
- 		9
1
4
5
2
3
8
7
6
6 		22
8
20
7
3
2
5
4
6
6 		-
6
6
5
3
2
7
8
4
1 		-
6
6
7
2
3
4
5
20
8 		-
DSR
DSR
SGND
TX
RX
RTS
CTS
DTR
DCD

Console RS232 port settings

  • 9600 bod (consult to DIP SW 2-1 and 2-2 positions and table on rear side of case)
  • 8 data bits
  • none parity
  • 1 stop bit
  • Hardware flow control using RTS/CTS signals pair (not need but advisable)

    Identification

     Connect console cable to "AUX" port and turn power switch to "ON" position. Some seconds later you may see following text on console: 
       RTSCOPE I386 v1.21



U.S. Robotics
Total Control (tm) NETServer 8/16

  Version:      3.2.5.92
  Build date:   Sep  9 1997
  Build time:   09:13:39

Enabling himem caching...
Initializing flash filesystem code...
Creating led_main() timer task...
Creating ns_main() NETServer task...
Deleting rtr_main() startup task...
Watchdog ENABLED!
Note: sysmsg[] strings compiled into operational code.
Initializing streams package

Unit 0 ACTIVE at ADDR = 0x3f8, STAT = 0x3fd
Unit 1 ACTIVE at ADDR = 0x8000, STAT = 0x9002
Found 9 ports....

Ethernet media type set in autodetection mode

10Base-T Network detected.
S0 is in console mode (9600 baud)

    Initialisation

    Reset old settings

    Set "NETServer configuration" DIP switch 4 to "ON" position and reboot (drop and restore power). After boot return DIP switch 4 back to "OFF" position to prevent erase your changes at next boot.

    Setup NETServer (manual)

    Connect console cable to "Console" port and press "Enter" on console. NETServer displays: 
    login:
     Enter !root and press "Enter" after "Password:" a displayed: 
    login: !root
Password:

Command>
    NETServer ready to configure from console using CLI. You may see command reference on type HELP.

    Setup NETServer (GUI/automate)

    After first time configure using "NETStarter" you may use "NETServer Manager Plus" software to manage NETServer by SNMP protocol.